Siemens SINUMERIK 840Di Diagnostic Manual page 109

11/2006
10631 Channel %1 axis %2 rests at working area limit %3
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = String ( + or - )
Definitions: The specified axis reaches the working area limitation in JOG mode.
Reaction: Alarm display.
Remedy: Setting data: Check 43420 WORKAREA_LIMIT_PLUS and 43430 WORKAREA_LIMIT_MINUS for
the working area limitation.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
10632 Channel %1 block %2 axis %3 reaches the coordinate system-specific
working area limit %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis, spindle number
%4 = String ( + or - )
Definitions: The specified axis violates the coordinate system-specific working area limitation. This is not detected
until the main run, either because the minimum axis values could not be determined before the
transformation or because there is an overlaid movement.
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Program other motion or do not perform overlaid motion.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10633 Channel %1 axis %2 is at coordinate system-specific working area limit
%3
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = String ( + or - )
Definitions: The specified axis reaches the coordinate system-specific working area limitation in JOG mode.
Reaction: Alarm display.
Remedy: Check the system parameter $P_WORKAREA_CS_xx for the coordinate system-specific working
area limitation.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
10640 [up to SW 3.x only] Channel %1 block %3 spindle %2 cannot stop during
gear change
Parameters: %1 = Channel number
%2 = Spindle number
%3 = Block number, label
Definitions: The spindle is in the oscillating mode for a gear change and is waiting for the PLC acknowledgement
stating that the gear change has taken place (interface signal: Gear has changed DB 31 - 48, DBX
16.3). During this phase spindle stop is not possible, initiated by Reset (DB 21 - 28, DBX 7.7) or NC
Stop axes plus spindle (DB 21 - 28, DBX 7.4).
Reaction: Alarm display.
Remedy: No remedial measures are necessary. The spindle-specific interface signal Spindle reset (DB 31 - 48,
DBX 2.2) cancels the oscillation mode.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-109