Siemens SINUMERIK 840Di Diagnostic Manual page 294

Overview of Alarms
NCK alarms
16699 Channel %1 block %2 following axis/spindle %3 leading axis/spindle %4
has not been defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions: An instruction to an undefined leading axis/spindle of a coupling is to be executed.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part programm.
Define the leading axis/spindle and activate, if necessary, before the instruction.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16700 Channel %1 block %2 axis %3 invalid feed type
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In a thread cutting function, the feed has been programmed in a unit that is impermissible.
1. G33 (thread with constant lead) and the feed have not been programmed with G94 or G95.
2. G33 (thread with constant lead) is active (modal) and G63 is programmed additionally in a following
block .conflict situation! (G63 is in the 2nd G group, G33, G331 and G332 are in the 1st G group).
3. G331 or G332 (rigid tapping) and the feed have not been programmed with G94.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Use only the feed type G94 or G95 in the thread cutting functions.
After G33 and before G63, deselect the thread cutting function with G01.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16710 Channel %1 block %2 axis %3 master spindle not programmed
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A master spindle function has been programmed (G33, G331, G95, G96) but the speed or the
direction of rotation of the master spindle is missing.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Add S value or direction of rotation for the master spindle in the displayed block.
Program Clear alarm with the RESET key. Restart part program
Continuation:
2-294
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006