Rep 12.30-171 Bm Tamper Assembly And Tamper 1 Motor - Xerox ColorQube 9303 Series Service Manual

REP 12.30-171 BM Tamper Assembly and Tamper 1 Motor

Parts List on PL 12.155.
Purpose
This procedure is used to repair the following components:
• BM tamper 1 motor, PL 12.155 Item
• BM rear tamper arm, PL 12.155 Item
• BM front tamper arm, PL 12.155 Item
• BM rear tamper rack, PL 12.155 Item
• BM front tamper rack, PL 12.155 Item
• BM rear tamper assembly, PL 12.155 Item
• BM front tamper assembly, PL 12.155 Item
• BM tamper gear,PL 12.155 Item 11.
• BM tamper bracket, PL 12.155 Item
• BM tamper rack guide, PL 12.155 Item
• BM tamper guide plate, PL 12.155 Item
• BM rear tamper finger, PL 12.155 Item
• BM front tamper finger, PL 12.155 Item
Removal
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Open the HVF BM front door and fully pull out the BM module.
2. Remove the crease blade knob (6d),
3. Remove the crease roll handle (6c),
4. Remove the BM front cover, PL 12.150 Item
5. Remove the left frame plate, PL 12.160 Item
ColorQube® 9303 Family
3.
5.
6.
7.
8.
9.
10.
12.
13.
15.
16.
17.
WARNING
GP 14. Disconnect the power cord from the cus-
WARNING
PL 12.150 Item 4.
PL 12.150 Item 5.
3.
17.
6. Figure 1, remove the tamper assembly.
1
Remove the cover and
disconnect the harness.
6
Move the tampers to align with the
slots to release each tamper from the
slot.
7
Remove the tamper
assembly.
Figure 1 Tamper assembly removal
February 2013
4-165
5
4
Remove 2 screws
Remove 2 screws
and earth connector
2
3
Remove 2 screws then
Remove 2 screws.
remove the motor.
Repairs/Adjustments
REP 12.30-171