Setting The Date/Time - Siemens SINAMICS Series Operating Instructions Manual

Operation
9.3 Controlling via the AOP30 operator panel
TM31 object
Table 9- 11 List of signals for the operation screen – TM31 object
Signal
Analog input 0 [V, mA]
Analog input 1 [V, mA]
Analog input 0, scaled
Analog input 1, scaled

Setting the date/time

Settings: MENU – Commissioning/Service – AOP settings
For date stamping in the case of fault codes and alarms, and for AOP time display on the
operation screen
The AOP30 contains a battery-buffered real-time clock.
You set the date and time on this screen.
Synchronization
You can also set whether and/or how the AOP30 and drive unit are to be synchronized.
Synchronizing the AOP with the drive enables fault codes and alarms to be date-stamped
and time-stamped (in the default setting, time-stamping occurs in accordance with the CU
runtime).
● None (factory setting)
The AOP30 and drive unit times are not synchronized.
● AOP → Drive
– Activating this option synchronizes the AOP and drive unit immediately, whereby the
– The current AOP30 time is transferred to the drive unit every time the AOP30 is
– At 02:00 (AOP time) every day, the current AOP30 time is transferred to the drive unit.
● Drive → AOP
– If a time-of-day master is connected to the drive, then activating this option enables
– The current drive unit time is transferred to the AOP30 every time the AOP30 is
– At 02:00 (AOP time) every day, the current drive unit time is transferred to the AOP30.
390
Parameter Short name
r4052[0] AI_UI
r4052[1] AI_UI
r4055[0] AI_%
r4055[1] AI_%
current AOP time is transferred to the drive unit.
started.
the AOP and drive unit to be synchronized immediately, whereby the current drive unit
time is transferred to the AOP30.
restarted.
Unit Scaling ( 100% = ...)
V, mA V: 100 V / mA: 100 mA
V, mA V: 100 V / mA: 100 mA
% V: 100 V / mA: 100 mA
% V: 100 V / mA: 100 mA
Operating Instructions, 12/2018, A5E34763375A
SINAMICS DCM DC Converter