Press Tool For Removal Of Shaft - ABB IRB 460 Series Product Manual

4 Repair
4.4.2 Replacing the tilthouse unit
Continued

Press tool for removal of shaft

The press tool replacing shaft is used both for removal and refitting. See figure
how to use the tool depending on purpose. For art. no. see
on page
The press tool replacing shaft and auxiliary bushing applied as shown in the figure
is used to disassemble the shaft.
The press tool consists of the parts shown in the figure.
xx1100000252
Press tool for fitting of shaft
The press tool replacing shaft is used both for removal and refitting. See figure
how to use the tool depending on purpose. For art. no. see
on page
The press tool replacing shaft applied as shown in the figure is used to fit the shaft.
The press tool consists of the parts shown in the figure. NOTE! The thread washer
Continues on next page
194
E Tilthouse
F Press washer (3HAC040028-002)
G Threaded bar M16
H Hydraulic cylinder
192.
C
A B
A Thread washer (2 pcs)
B Auxiliary shaft (3HAC040035-001) Only used on removal.
C Shaft axis 2
D Upper arm
E Tilthouse
F Support bushing (3HAC040029-002)
G Hydraulic cylinder
H Threaded bar M16
192.
© Copyright 2012-2018 ABB. All rights reserved.
Required equipment
D E F
Required equipment
Product manual - IRB 460
3HAC039842-001 Revision: P
G H A