ABB IRB 460 Series Product Manual page 200

4 Repair
4.4.2 Replacing the tilthouse unit
Continued
12
13
14
Continues on next page
200
Action
Remove the small VK cover from the inside
with the help of a short punch or similar.
Remove the lock nut.
Apply the press tool shaft and auxiliary bushing
used for removing the shaft, as shown in the
figure in:
• Press tool for removal of shaft on
page 194
Note
A longer threaded bar M16 is needed when re-
moving the shaft than the one specified when
fitting.
© Copyright 2012-2018 ABB. All rights reserved.
Note
xx1100000233
Parts:
A: VK cover
B: Punch
xx1100000234
For art.no:s. see Required equipment
on page 192.
The longer threaded bar: M16 length
450 mm
Product manual - IRB 460
3HAC039842-001 Revision: P