ABB IRB 460 Series Product Manual page 175

Removing the complete arm system
Use this procedure to remove the complete arm system.
1
2
3
4
Product manual - IRB 460
3HAC039842-001 Revision: P
Action
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
Action
Decide which calibration routine to use, and
take actions accordingly prior to beginning
the repair procedure.
Move the robot to the transport position.
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot work-
ing area.
Run an overhead crane to a position above
the robot.
© Copyright 2012-2018 ABB. All rights reserved.
4.3.5 Replacing the base, including axis 1 gearbox
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in
routine on page
Read more about reference calibration for
Pendulum Calibration in Operating manu-
al - Calibration Pendulum.
Note
xx1000001155
4 Repair
Continued
Reference calibration
358.
m
Continues on next page
175