ABB IRB 460 Series Product Manual page 128

3 Maintenance
3.4.3 Changing oil, gearbox axes 2 and 3
Continued
Draining, axes 2 and 3
Use this procedure to drain oil in gearbox axes 2 and 3.
When using oil change equipment, follow the instructions enclosed with kit.
1
2
3
4
5
Filling, axes 2 and 3
Use this procedure to fill gearboxes of axes 2 and 3 with oil.
When using oil change equipment, follow the instructions enclosed with kit.
1
Continues on next page
128
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
WARNING
Handling gearbox oil involves several safety
risks. Before proceeding, please read the
safety information in the section
during work with gearbox lubricants (oil or
grease) on page 36.
Remove the ventilation hole plug.
Remove the oil plug, draining, and drain gear-
box using a hose with a nipple and an oil col-
lecting vessel.
Refit the oil plug, draining.
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
© Copyright 2012-2018 ABB. All rights reserved.
Note
Safety risks
Shown in Location of oil plugs on
page 126.
Shown in Location of oil plugs on
page 126.
Vessel capacity is specified in
quired equipment on page
Draining is time-consuming.
Elapsed time varies depending on the
temperature of the oil.
Tightening torque: 25 Nm.
Note
Re-
127.
Product manual - IRB 460
3HAC039842-001 Revision: P