Installation Of Signal Lamp, Upper Arm (Option) - ABB IRB 460 Series Product Manual

2 Installation and commissioning

2.3.9 Installation of signal lamp, upper arm (option)

2.3.9 Installation of signal lamp, upper arm (option)
General
As an option, a signal lamp can be installed on the robot. The lamp is activated
when the controller is in the MOTORS ON state.
Location of signal lamp, upper arm
The signal lamp is located on the tilthouse unit, as shown in figure.
B
xx1000001287
A
B
C
Required equipment
Equipment, etc.
Signal lamp kit
Gasket
Standard toolkit
Continues on next page
80
A
C
Signal lamp
Attachment screw M6x8 (2 pcs)
Motor cover
© Copyright 2012-2018 ABB. All rights reserved.
Article number Note
Spare parts on Complete kit with signal lamp,
page 389. cables, adapter, gasket, screws etc.
3HAC033206-001 Fitted between motor and cable
gland, replace if damaged.
Content is defined in section
ard tools on page
Stand-
383.
Product manual - IRB 460
3HAC039842-001 Revision: P