ABB IRB 460 Series Product Manual page 213

Pull tool, shaft
The pull tool shaft is used to remove the shaft, bearing and T-ring in the upper arm.
For art. no. see
The pull tool shaft is using the same parts as the press tool upper arm but the
press bushing is replaced by the support bushing. See part marked red in the
figure.
xx1100000270
Required equipment
Equipment, etc.
Upper arm, axis 4
V-ring
T-ring
Adapter
Product manual - IRB 460
3HAC039842-001 Revision: P
Required equipment on page
B
A C
A Threaded bar M16
B Thread washer
C Hydraulic cylinder
D Support bushing (3HAC040026-004). Only used at removal.
E Auxiliary shaft (3HAC040026-002)
F Shaft
G Bearing
H Lower arm
J Upper arm
© Copyright 2012-2018 ABB. All rights reserved.
213.
H
E
D F
Art.no.
For spare part no. see:
• Spare parts on page389
2216264-16
3HAC022581-001
3HAC040027-001
4 Repair
4.4.3 Replacing the upper arm
Continued
J
G
Note
Includes:
• 3HAC037314-001
bushing (2 pcs)
The adapter consists of two
parts: the adapter and a pro-
tective cover. Always use the
protective cover together with
the adapter!
Continues on next page
213