ABB IRB 460 Series Product Manual page 202

4 Repair
4.4.2 Replacing the tilthouse unit
Continued
20
21
22
Premounting outer race of bearing and radial sealing, axis 2 side
Use this procedure to fit the outer race of the bearing and radial sealing in the
tilthouse on the axis 2 side, before fitting the tilthouse to the upper arm.
1
2
3
Continues on next page
202
Action
Remove the tilthouse and lift it to a safe place.
Check that bearings are kept clean. Replace if
damaged.
Force away the sealing ring with a screwdriver
or similar.
The sealing ring must be replaced with new
ones when refitting.
If needed replace bearings.
Action
This work is best done on a workbench or sim-
ilar.
Fit the radial sealing in the hole.
Apply some grease in the hole for the bearings.
© Copyright 2012-2018 ABB. All rights reserved.
Note
xx1100000237
xx1100000243
Note
Art.no. is specified in Required equip-
ment on page 192.
Product manual - IRB 460
3HAC039842-001 Revision: P