ABB IRB 460 Series Product Manual page 247

12
13
14
15
Preparations - fitting outer races of the bearings in link
Use this procedure to fit the outer races of the bearings in the link. Fit the outer
races one at a time using the press tool as shown in the figures. For art. no. see
Required equipment on page
Product manual - IRB 460
3HAC039842-001 Revision: P
Action
Remove the POM sealing or the support ring
(depending on version of sealing structure).
Wipe off residual grease.
Valid for design with support ring.
Remove the radial sealing from the link, if the
link is to be replaced with a new spare part.
Replace the radial sealing, if damaged.
If needed, replace bearings.
© Copyright 2012-2018 ABB. All rights reserved.
4.4.6 Replacing the linkage - link
Note
xx1100000199
242.
4 Repair
Continued
Continues on next page
247