Dot1As Pdelay-Threshold - Dell N1100-ON Reference Manual

Is Measuring Delay............................. No
Propagation Delay.............................. 0
Port Role...................................... Disabled
PDELAY Threshold............................... 2500
PDELAY lost responses allowed.................. 3
Neighbor Rate Ratio............................ 0
Initial Sync Interval.......................... -3
Current Sync Interval.......................... -3
Initial Pdelay Interval........................ 3
Current Pdelay Interval........................ 0
Initial Announce Interval...................... 3
Current Announce Interval...................... 0
Sync Receipt Timeout........................... 5
Announce Receipt Timeout....................... 3

dot1as pdelay-threshold

Use this command to configure the propagation delay threshold in
nanoseconds, above which an interface is not considered capable of
participating in the AS protocol.
Use the no form of the command to return the threshold to the default.
Syntax
dot1as pdelay-threshold thresh-val
no dot1as pdelay-threshold
Default Configuration
By default, the number of expiries is set to 2500 nanoseconds for copper
interfaces and 8000 nanoseconds for fiber thresholds.
Command Mode
Interface Configuration
User Guidelines
IEEE 802.1AS must also be enabled globally as well as on an interface to
become operational.
1120
Audio Visual Bridging Commands