D-Link DXS-3600 Series Cli Reference Manual page 919

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, this value is 1.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The OSPF router will determine a designated router for the multi-access network.
This command sets the priority used to determine the OSPF Designated Router (DR) for a network. If two
routers attempt to become the DR, the router with the higher router priority will be elected the DR. If the
routers have the same priority, the router with the higher router ID takes precedence.
Only routers with non-zero router priority values are eligible to become the designated or backup
designated router.
Example
This example shows how to configure the OSPF priority value to 3 on the VLAN 1 interface.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip ospf priority 3
Switch(config-if)#
75-19 ip ospf bfd
This command is used to enable BFD on an interface. Use the no command to disable BFD on an
interface.
ip ospf bfd
no ip ospf bfd
Parameters
None.
Default
By default, this feature is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command configures the Bidirectional Forwarding Detection (BFD) status of the interface. When
enabled, it will try to create BFD sessions with its OSPF neighbors on this interface. If the BFD session
goes down, the related OSPF neighbor adjacency will be removed immediately.
Example
This example shows how to enable BFD on the interface VLAN 1.
Switch# configure terminal
914