Show Ip Route - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
1.0.0.2
2.0.0.2
4.0.0.2
7.255.255.254
8.0.0.2
11.0.0.2
131.0.0.2
132.0.0.2
133.0.0.2
4.0.0.2
Distribute list:
vlan1 filtered by abc.
vlan8 filtered by abc.
vlan11 filtered by abc.
External-1 Distance 110,External-2 Distance 115,inter-area distance 90, intra-area
distance 80.
Routing Protocol is "BGP 1"
Router ID 222.200.23.1
IGP synchronization is disabled
Redistributing:
Default local preference is 100
Aggregated network(s)
Neighbor(s)
Maximum path: 1
External distance 70, internal distance 130
Switch#
85-10

show ip route

This command is used to display the entry in the routing table.
show ip route [vrf VRF-NAME] [[IP-ADDRESS [MASK] | PROTOCOL] | hardware]
Parameters
vrf VRF-NAME
IP-ADDRESS
MASK
PROTOCOL
hardware
Default
None.
Command Mode
(Optional) Specifies to display the VRF routing table.
(Optional) Specifies the network address of which routing information
should be displayed.
(Optional) Specifies the subnet mask for the specified network.
(Optional) Specifies the routing protocol, or the following keywords:
static, connected.
(Optional) Specifies to display the routes that have been written into
chip.
1064