Protocol Independent Multicast (Pim) Snooping Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
84. Protocol Independent Multicast (PIM)
Snooping Commands
84-1 ip pim snooping
This command is used to enable the PIM snooping function. To disable this function, use the no
command.
ip pim snooping
no ip pim snooping
Parameters
None.
Default
By default, this function is disabled globally and on all VLAN interfaces.
Command Mode
Global Configuration Mode.
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
For a VLAN to operate with PIM snooping, both the global state and per interface state must be enabled.
Example
This example shows how to enable the PIM snooping global state.
Switch# configure terminal
Switch(config)# ip pim snooping
Switch(config)#
This example shows how to enable PIM snooping on a VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip pim snooping
Switch(config-vlan)#
84-2 clear ip pim snooping statistics
This command is used to clear the PIM snooping related statistics.
clear ip pim snooping statistics {all | vlan VLAN-ID}
Parameters
1050