Virtual Lan (Vlan) Tunnel Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
115.

Virtual LAN (VLAN) Tunnel Commands

115-1 dot1q inner ethertype
This command is used to specify the system's inner TPID. Use the no command to revert the setting to
default.
dot1q inner ethertype VALUE
no dot1q inner ethertype
Parameters
VALUE
Default
The default inner TPID is 0x8100.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to configure the inner TPID of the system. The inner TPID is used to decide if the
ingress packet is C-tagged. The Inner TPID is per system configurable.
Example
This example shows how to configure the inner TPID to 0x9100.
Switch# configure terminal
Switch(config)# dot1q inner ethertype 0x9100
Switch(config)#
115-2 dot1q tunneling ethertype
This command is used to specify the outer TPID for the service VLAN tag. Use the no command to
restore the setting back to default setting.
dot1q tunneling ethertype VALUE
no dot1q tunneling ethertype
Parameters
VALUE
Default
Specifies the system's inner TPID. The value is in the hexadecimal
form. The range is 0x1 to 0xFFFF.
Specifies the outer TPID for the service VLAN tag. The value is in the
hexadecimal form. The range is 0x1 to 0xFFFF.
1319