Timers Basic - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
This command is used to display interface specific information for RIP.
Example
This example shows how to display interface specific information for RIP.
Switch# Show ip rip interface
vlan1 is up, line protocol is up
Routing Protocol: RIP
Receive RIP packets
Send RIP packets
Send v2-broadcast: Disabled
Authentication Mode: text
Passive interface: Disabled
IP interface address:
10.72.63.80/8
vlan2 is up, line protocol is up
Routing Protocol: RIP
Receive RIP packets
Send RIP packets
Send v2-broadcast: Disabled
Authentication Mode: text
Passive interface: Disabled
IP interface address:
20.72.63.80/8
IP summary address:
11.0.0.0/8
Total Entries: 2
Switch#
93-15

timers basic

This command is used to configure the RIP network timers. To restore the default timers use the no form
of this command.
timers basic UPDATE INVALID FLUSH
no timers basic
Parameters
UPDATE
INVALID
FLUSH
Default
Specifies the update interval in seconds at which the update message
is sent. The range is from 1 to 65535.
Specifies the invalidate timer in seconds. The range is from 1 to
65535.
Specifies the flush timer in seconds. The range is from 1 to 65535.
1162