Digital Diagnostics Monitoring (Ddm) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
29. Digital Diagnostics Monitoring (DDM)
Commands
29-1 show interfaces transceiver
This command is used to display the current SFP/SFP+/QSFP+ module operating parameters.
show interfaces [INTERFACE-ID [,|-] transceiver [detail]
Parameters
INTERFACE-ID
,
-
detail
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the current SFP/SFP+/QSFP+ module operating transceiver monitoring
parameters values for specified ports.
Example
This example shows how to display current operating parameters for all ports valid for transceiver
monitoring.
Switch# show interfaces transceiver
++ : high alarm, +
mA: milliamperes, mW: milliwatts
Transceiver Monitoring traps: Alarm and warning
port
---------- -----------
eth1/0/28
eth1/0/30
(Optional) Specifies multiple interfaces for transceiver monitoring
status display. If no interface ID is specified, transceiver monitoring
statuses on all valid interfaces are displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces are allowed before and
after the comma.
(Optional)Specifies a range of interfaces. No spaces are allowed
before and after the hyphen.
(Optional) Specifies to display more detailed information.
: high warning, -
Temperature Voltage
(Celsius) (V)
---------- ------------ ---------- ----------
30.090 3.353
30.090 3.353
: low warning, -- : low alarm
Bias Current TX Power
(mA) (mW/dbm)
16.794(++) 0.258
-5.900
16.794(++) 0.258
419
RX Power
(mW/dbm)
0.000
-(--)
0.000