D-Link DXS-3600 Series Cli Reference Manual page 605

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
MULTIPLIER
level-1
level-2
Default
By default, this value is 3.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the hello multiplier. The hello multiplier times the hello interval is equal to
the hold time, which is advertised in IS-IS hello packets. Using a smaller hello multiplier will get fast
convergence. But it can result in more routing instability. When network stability is needed, set the hello
multiplier to a larger value.
Example
This example shows how to configure the level 1 hello multiplier to 5 on interface VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# isis hello-multiplier 5 level-1
Switch(config-if)#
48-17 isis hello padding
This command is used to enable the IS-IS hello padding on a specific interface. Use the no command to
disable IS-IS hello padding.
isis hello padding
no isis hello padding
Parameters
None.
Default
By default, this feature is enabled on each interface.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the hello multiplier. The range is from 2 to 100.
(Optional) Specifies to configure the hello multiplier independently for
level 1 adjacencies.
(Optional) Specifies to configure the hello multiplier independently for
level 2 adjacencies.
600