D-Link DXS-3600 Series Cli Reference Manual page 1222

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
When the username argument is not specified, all configured users will be displayed. The community
string created will not displayed by this command.
Example
This example shows how SNMP users are displayed.
Switch# show snmp user authuser
User name: authuser
Security Model: v2c
Group Name: VacmGroupName
IP access control list: HB5
User name: authuser
Security Model: v3 priv
Group Name: VacmGroupName
Authentication Protocol: MD5
Privacy Protocol: DES
Engine ID: 00000009020000000C025808
IP access control list:
Total Entries: 2
Switch#
101-3 snmp-server community
This command is used to configure the community string to access the SNMP. Use the no command to
remove the community string,
snmp-server community [0 | 7] COMMUNITY-STRING [view VIEW-NAME] [ro | rw] [access IP-
ACL-NAME] [context CONTEXT]
no snmp-server community [0 | 7] COMMUNITY-STRING
Parameters
0 COMMUNITY-STRING
7 COMMUNITY-STRING
view VIEW-NAME
ro
rw
access IP-ACL-NAME
context CONTEXT
Default
(Optional) Specifies the community string in the plain text form with a
maximum of 32 alphanumeric characters. This is the default option.
(Optional) Specifies the community string in the encrypted form.
(Optional) Specifies a view name of a previously defined view. It
defines the view accessible by the SNMP community.
(Optional) Specifies read-only access.
(Optional) Specifies read-write access.
(Optional) Specifies the name of the standard access list to control the
user to use this community string to access to the SNMP agent.
Specifies the valid user in the source address field of the access list
entry.
(Optional) Specifies the SNMP context name.
1217