D-Link DXS-3600 Series Cli Reference Manual page 588

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
,
-
utilization
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the switch's physical port utilization.
Example
This example shows how to display the switch's port utilization.
Switch# show interfaces utilization
Port
----------- -------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
Total Entries: 8
Switch#
47-10 show interfaces gbic
This command is used to display GBIC status information.
show interfaces [INTERFACE-ID [,|-]] gbic
Parameters
INTERFACE-ID
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces are allowed before and
after the comma.
(Optional)Specifies a range of interfaces. No spaces are allowed
before and after the hyphen.
(Optional) Specifies to display the utilization information.
TX packets/sec RX packets/sec
--------------
0 0
1488109 0
0 0
0 1488109
0 0
0 0
0 0
0 0
(Optional) Specifies the interface ID. If no interface is specified, the
GBIC status information on all GBIC interfaces will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces are allowed before and
Utilization
-----------
0
50
0
50
0
0
0
0
583