D-Link DXS-3600 Series Cli Reference Manual page 883

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Reply from 192.1.1.1, time=40ms
Trace complete.
Switch#
This example shows how to trace route the LSP for network 110.1.1.0/24.
Switch# traceroute mpls ipv4 110.1.1.0/24
Reply from 170.1.1.1, time<10ms
Request timed out
Trace complete.
Switch#
71-46 trust exp
This command is used to trust the incoming label's top-most EXP as the priority. Use the no command to
disable the trust.
trust exp
no trust exp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
MPLS QoS Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to trust the incoming label's top-most EXP as the priority. If the EXP is trusted, the
matched packets are scheduled according to the EXP to the priority mapping of the MPLS QoS policy.
Otherwise, the packets are scheduled according to the 802.1p priority.
Example
This example shows how to enable trust EXP.
Switch# configure terminal
Switch(config)# mpls qos policy policy1
Switch(config-mpls-qos)# trust exp
Switch(config-mpls-qos)#
878