D-Link DXS-3600 Series Cli Reference Manual page 813

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ip msdp peer minimum-ttl PEER-ADDRESS TTL
no ip msdp peer minimum-ttl PEER-ADDRESS
Parameters
PEER-ADDRESS
TTL
Default
By default, this value is 0.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the Source-Active messages are sent from MSDP peers, If the TTL of multicast data packets in
Source-Active message will be decreased, if the decreased TTL is smaller than minimum TTL value of
the MSDP peer the Source-Active message was sent to, the Source-Active will not be sent out.
Example
This example shows how to configure the minimum TTL value.
Switch# configure terminal
Switch(config)# ip msdp peer minimum-ttl 10.1.1.1 100
Switch(config)#
68-15 ip msdp peer sa-cache-maximum
This command is used to configure the maximum number of Source-Active cache entries learned from
the peer. Use the no command to configure the number to the default value.
ip msdp peer sa-cache-maximum PEER-ADDRESS {COUNT | none｝
no ip msdp peer sa-cache-maximum PEER-ADDRESS
Parameters
PEER-ADDRESS
COUNT
none
Default
By default, the maximum number of Source-Active cache entries is none.
Specifies the MSDP peer IP address.
Specifies the minimum TTL value for data-encapsulated Source-Active
messages sent to specified MSDP peers. The range is from 0 to 255.
Specifies the MSDP peer IP address.
Specifies the maximum number of Source-Active cache entries
learned from the peer. The range is form 0 to 4096.
Specifies that no limitation is applied for the number of Source-Active
cache entries.
808