D-Link DXS-3600 Series Cli Reference Manual page 1372

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
REMOTE-LABEL
Default
None.
Command Mode
Xconnect Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available when the manual option is specified in the xconnect command. That is,
the local label and remote label are manual assigned. If the manual option is not specified, the local and
remote labels are assigned and exchanged by the LDP protocol. The service will only be started after the
label is assigned.
Example
This example shows how to assign the local label and the remote label for a manual PW.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/2
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls manual
Switch(config-if-xconn)# mpls label 100 200
Switch(config-if-xconn)#
118-5 name
This command is used to configure the name of a VC. Use the no command to reset the name of the VC
to default setting.
name STRING
no name
Parameters
STRING
Default
Each VC has a default name composed by a fixed prefix "VC" plus VC-ID/Peer-Address. For example,
VC8/5.5.5.5.
Command Mode
Xconnect Configuration Mode.
Backup Xconnect Configuration Mode.
Command Default Level
identified.
Specifies the output label used to encapsulate the packet transmitted
to the PW.
Specifies the name of the VC. This string can be up to 64 case-
sensitive characters long.
1367