D-Link DXS-3600 Series Cli Reference Manual page 615

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to generate and accept only new-style TLVs on level 2.
Switch# configure terminal
Switch(config)# router isis
Switch(config-router)# metric-style wide level-2
Switch(config-router)#
48-30 net
This command is used configure a Network Entity Table (NET) for the IS-IS routing process. Use the no
command to remove a NET.
net NET
no net NET
Parameters
NET
Default
By default, no NET is configured.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
An Intermediate System (IS) is identified by an address known as the NSAP. The NSAP is divided up into
three parts as specified by ISO 10589. A NET is an NSAP where the last byte is always the n-selector
and is always zero. A NET can be from 8 to 20 bytes in length. Multiple NETs can be configured to merge
or split areas. This implementation is just for IP routing only, so the NET must be configured to define the
system ID and area ID.
Example
This example shows how to configure the switch with a NET which consists of the system ID
0001.0001.0001 and area address 49.0001.
Switch# configure terminal
Switch(config)# router isis
Switch(config-router)# net 49.0001.0001.0001.0001.00
Switch(config-router)#
48-31 redistribute
This command is used to redistribute other protocol routes into the IS-IS routing domain. Use the no
command to remove the redistribution.
Enter the NET Network Services Access Point (NSAP) address here.
610