D-Link DXS-3600 Series Cli Reference Manual page 545

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Leave: 60.
Leave-all: 1000.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the GVRP timer value on a port.
Example
This example shows how to configure the leave-all timer to 500 hundredths of a second on interface
Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# gvrp timer leave-all 500
Switch(config-if)#
43-8 gvrp nni-bpdu-address
This command is used to configure the GVRP BPDU address in the service provider site. Use the no
form of the command to reset it to the default setting.
gvrp nni-bpdu-address {dot1d | dot1ad}
no gvrp nni-bpdu-address
Parameters
dot1d
dot1ad
Default
Dot1d GVRP address.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Generally, the GVRP BPDU address uses a Dot1d GVRP address. This command is used to designate
the GVRP BPDU address as a Dot1d or Dot1ad GVRP address in the service provider site. It will only
take effect on VLAN trunk ports that behave as the NNI ports in the service provider site.
Example
This example shows how to configure the GVRP PDU address in service provider site to dot1d.
Specifies to set the GVRP BPDU protocol address to 802.1d GVRP
address 01:80:C2:00:00:21.
Specifies to set the GVRP BPDU protocol address to 802.1ad GVRP
address 01:80:C2:00:00:0D.
540