D-Link DXS-3600 Series Cli Reference Manual page 729

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
When disabling the transmission of the Capabilities TLV, LLDP-MED on the physical interface will be
disabled at the same time. In other words, all LLDP-MED TLVs will not be sent, even when other LLDP-
MED TLVs are enabled to transmit.
By default, the switch only sends LLDP packets until it receives LLDP-MED packets from the end device.
The switch continues to send LLDP-MED packets until it only receives LLDP packets.
Example
This example shows how to enable transmitting LLDP-MED TLVs and LLDP-MED Capabilities TLVs.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp med-tlv-select capabilities
Switch(config-if)#
61-10 lldp receive
This command is used to enable a physical interface to receive LLDP messages. Use the no form of this
command to disable receiving LLDP messages.
lldp receive
no lldp receive
Parameters
None.
Default
LLDP is enabled on all supported interfaces.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable a physical
interface to receive LLDP messages. When LLDP is not running, the switch doesn't receive LLDP
messages.
Example
This example shows how to enable a physical interface to receive LLDP messages.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp receive
Switch(config-if)#
61-11 lldp reinit
This command is used to configure the minimum time of re-initialization the delay interval on the switch.
Use the no form of this command to return to the default settings.
724