Multicast Source Discovery Protocol (Msdp) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
68. Multicast Source Discovery Protocol (MSDP)
Commands
68-1 ip msdp
This command is used to enable the MSDP function. To disable this function, use the no command.
ip msdp
no ip msdp
Parameters
None.
Default
By default, this feature is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
None.
Example
This example shows how to enable the MSDP function.
Switch# configure terminal
Switch(config)# ip msdp
Switch(config)#
68-2 ip msdp connect-retry-interval
This command is used to configure the interval at which MSDP peers will wait after peering sessions are
reset before attempting to re-establish. Use the no command to revert to default setting.
ip msdp connect-retry-interval SECONDS
no ip msdp connect-retry-interval
Parameters
SECONDS
Default
By default, this value is 30 seconds.
Specifies the connect retry time interval in seconds. The range is from
1 to 65535.
799