D-Link DXS-3600 Series Cli Reference Manual page 1276

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only applicable on a sub-VLAN and is used to configure the IP address range of a sub-
VLAN. Configuring IP address range(s) of a sub-VLAN can reduce the overhead when the switch is the
ARP proxy between sub-VLANs. The wrong configuration of IP address ranges may cause IP traffic not
to be routed correctly. A sub-VLAN can have one or more IP address ranges. The configured IP address
range should not overlap with the existed address ranges of other sub-VLANs and must belong to the
subnet of the super VLAN interface. Within a sub-VLAN, the configured IP address range will be merged
into other range(s) if applicable.
Example
This example shows how to configure the IP address range of the sub-VLAN 5.
Switch# configure terminal
Switch(config)# vlan 5
Switch(config-vlan)# subvlan-address-range 192.168.10.1 192.168.10.50
Switch(config-vlan)#
106-4 show supervlan
This command is used to display the configuration of the super VLAN and its sub-VLANs.
show supervlan [VLAN-ID [, | -]]
Parameters
VLAN-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the configuration of the super VLAN and its sub-VLANs.
Example
This example shows how to display the configuration of all super VLANs.
Switch# show supervlan
(Optional) Specifies the ID of the super VLAN to display.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is required before and after the
comma.
(Optional) Specifies a range of VLANs. No space is required before
and after the hyphen.
1271