D-Link DXS-3600 Series Cli Reference Manual page 756

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
snmp-server enable traps loopback-detection
no snmp-server enable traps loopback-detection
Parameters
None.
Default
By default, this feature is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable the sending of SNMP notifications for loopback detection. Use the no
command to return to the default settings.
Example
This example shows how to enable the sending of SNMP notifications for loopback detection.
Switch# configure terminal
Switch(config)# snmp-server enable traps loopback-detection
Switch(config)#
751