D-Link DXS-3600 Series Cli Reference Manual page 1151

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Route-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to modify the metric of routes.
Example
This example shows how to configure the metric of routes that pass the route map match to 100.
Switch# configure terminal
Switch(config)# route-map example permit 10
Switch(config-route-map)# match ip address IPACL_01
Switch(config-route-map)# set metric 100
Switch(config-route-map)#
91-13 set metric-type
This command is used to configure the type of OSPF AS external route.
set metric-type {type-1 | type-2}
no set metric-type
Parameters
type-1
type-2
Default
None.
Command Mode
Route-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to set the type of OSPF AS external route.
Example
This example shows how to configure the route type to type-2 for the OSPF AS external routes that pass
the route map match.
Switch# configure terminal
Switch(config)# route-map example permit 10
Switch(config-route-map)# match ip address IPACL_01
Switch(config-route-map)# set metric-type type-2
Switch(config-route-map)#
Specifies to use the OSPF external type-1 metric.
Specifies to use the OSPF external type-2 metric.
1146