D-Link DXS-3600 Series Cli Reference Manual page 810

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
68-10 ip msdp peer hold-time
This command is used to configure the interval at which an MSDP peer will wait for keep-alive messages
from other peers before declaring them down. Use the no command to configure the interval to the
default value.
ip msdp peer hold-time PEER-ADDRESS {SECONDS | infinity}
no ip msdp peer hold-time PEER-ADDRESS
Parameters
PEER-ADDRESS
SECONDS
infinity
Default
By default, the hold time interval is 75 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The hold time interval must be larger than keep-alive time configured on the remote side of the MSDP
TCP connection. Otherwise the MSDP TCP connection may be disconnected before receiving the MSDP
keep-alive message.
Example
This example shows how to configure the hold time interval to 60.
Switch# configure terminal
Switch(config)# ip msdp peer hold-time 10.1.1.1 60
Switch(config)#
68-11 ip msdp peer sa-filter-in
This command is used to control the Source-Active messages received from a peer. Use the no
command to return this to the default setting.
ip msdp peer sa-filter-in PEER-ADDRESS [list ACCESS-LIST-NAME]
no ip msdp peer sa-filter-in PEER-ADDRESS
Parameters
PEER-ADDRESS
Specifies the MSDP peer IP address.
Specifies the hold time interval of the MSDP peer in seconds. The
range is from 3 to 65535.
Specifies that the connection between two peers is never torn down.
Specifies the MSDP peer IP address.
805