D-Link DXS-3600 Series Cli Reference Manual page 696

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# ipv6 snooping policy policy1
Switch(config-ipv6-snooping)# limit address-count 25
Switch(config-ipv6-snooping)#
56-4 ipv6 snooping attach-policy
This command is used to apply an IPv6 snooping policy to a specified VLAN. Use the no command to
remove the binding.
ipv6 snooping policy attach-policy POLICY-NAME
no ipv6 snooping policy attach-policy
Parameters
POLICY-NAME
Default
No IPv6 snooping policy is applied.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
After an IPv6 snooping policy has been created, use this command to apply the policy on a specific VLAN.
Example
This example shows how to enable IPv6 snooping on VLAN 200.
Switch# configure terminal
Switch(config)# ipv6 snooping policy policy1
Switch(config-ipv6-snooping)# limit address-count 100
Switch(config-ipv6-snooping)# exit
Switch(config)# vlan 200
Switch(config-vlan)# ipv6 snooping attach-policy policy1
Switch(config-vlan)#
56-5 ipv6 snooping station-move deny
This command is used to deny the station move function for IPv6 snooping entries. Use the no command
to reset it to default.
ipv6 snooping station-move deny
no ipv6 snooping station-move deny
Specifies the name of the snooping policy.
691