Spanning Tree Protocol (Stp) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
103.

Spanning Tree Protocol (STP) Commands

103-1 clear spanning-tree detected-protocols
This command is used to restart the protocol migration.
clear spanning-tree detected-protocols {all | interface INTERFACE-ID}
Parameters
all
interface INTERFACE-ID
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Using this command the port protocol migrating state machine will be forced to the SEND_RSTP state.
This action can be used to test whether all legacy bridges on a given LAN have been removed. If there is
no STP Bridge on the LAN, the port will be operated in the configured mode, either in the RSTP or MSTP
mode. Otherwise, the port will be operated in the STP mode.
Example
This example shows how to trigger the protocol migration event for all ports.
Switch# clear spanning-tree detected-protocols all
Clear spanning-tree detected-protocols? (y/n) [n] y
Switch#
103-2 show spanning-tree
This command is used to display the information of spanning tree protocol operation. This command is
only for STP and RSTP.
show spanning-tree [interface [INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
,
Specifies to trigger the detection action for all ports.
Specifies the port interface that will be triggered the detecting action.
Specifies the interface ID to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
1246