D-Link DXS-3600 Series Cli Reference Manual page 1044

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure the register suppression time. Use the no form of the command to
revert to the default setting.
ip pim register-suppression SECONDS
no ip pim register-suppression
Parameters
SECONDS
Default
By default, this value is 60 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When a DR receives the register stop message, it will start the suppression timer. During the suppression
period, a DR stops sending the register message to the RP.
Use this command on the first hop router. The value of the register probe time must be less than half the
value of the register suppression time to prevent a possible negative value in the setting of the register
stop timer. The minimal value for the register suppression time is 3.
Example
This example shows how to configure the register suppression time to 30 seconds.
Switch# configure terminal
Switch(config)# ip pim register-suppression 30
Switch(config)#
83-11 ip pim rp-address
This command is used to statically configure the RP address for multicast groups. To remove an RP
address, use the no form of this command.
ip pim rp-address IP-ADDRESS [group-list ACCESS-LIST-NAME]
no ip pim rp-address IP-ADDRESS
Parameters
IP-ADDRESS
group-list ACCESS-LIST-
NAME
Default
None.
Specifies the register suppression timeout value in seconds. The range
is from 3 to 65535.
Specifies the IP address of the RP.
Specifies a standard access list that contains multiple groups. If no
group list is specified, the RP will be mapped to all multicast groups.
1039