D-Link DXS-3600 Series Cli Reference Manual page 997

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
port-shutdown
hibernation
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The user can enable or disable link detection, length detection, dimming LEDs, port shutdown, and
hibernation using this command.
When link detection is enabled, the device can save power on the inactive ports.
When length detection is enabled, the device can reduce the power consumption of a port dependent on
the detected cable length.
When dim LED is enabled, the device will turn off all the port's LEDs in the specified time range to save
power.
When port shutdown is enabled, the device will shut off all ports in the specified time range to save power.
When Energy-Efficient Ethernet (EEE) is enabled, the device will activate EEE power saving for those
EEE enabled ports.
When hibernation is enabled, the device will enter the hibernation mode in the specified time range to
save power.
Example
This example shows how to enable power saving by shutting off the switch's ports and toggle the switch
into the hibernation mode.
Switch# configure terminal
Switch(config)# power-saving port-shutdown
Switch(config)# power-saving hibernation
Switch(config)#
79-3 power-saving eee
This command is used to enable the Energy-Efficient Ethernet (EEE) function on the specified port(s).
Use the no form of the command to disable the EEE function.
power-saving eee
no power-saving eee
Parameters
None.
Default
Specifies that power saving will be applied by scheduled port
shutdown.
Specifies that power saving will be applied by scheduled system
hibernation. This feature can only be used when physical stacking is
disabled.
992