D-Link DXS-3600 Series Cli Reference Manual page 1333

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the service VLAN tag Ethernet type.
Example
This example shows how to display the 802.1Q TPID setting for all interfaces.
Switch#show dot1q ethertype
802.1q inner Ethernet Type is 0x8100
eth1/0/1
802.1q tunneling Ethernet Type is 0x88a8
eth1/0/2
802.1q tunneling Ethernet Type is 0x88a8
Switch#
115-12 show dot1q-tunnel
This command is used to display the dot1q VLAN tunneling configuration on interfaces.
show dot1q-tunnel [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
,
-
Default
Specifies the interface ID.
(Optional )Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
(Optional) Specifies the interfaces that will be displayed. If not
specified, display all 802.1Q tunnel ports.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
1328