D-Link DXS-3600 Series Cli Reference Manual page 990

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
INTEFACE-ID
,
-
address
vlan VLAN-ID
.
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the current port security settings.
Example
This example shows how to display the port security settings of interfaces Ethernet 1/0/1 to 1/0/3.
Switch# show port-security interface ethernet 1/0/1-3
D:Delete-on-Timeout
Interface
No.
------------ ---- ---- -------- -------------------- ---- -------- ------------
eth1/0/1
eth1/0/2
eth1/0/3
Total Entries: 3
Switch#
78-3 snmp-server enable traps port-security
This command is used to enable the sending of SNMP notifications for port security address violations.
Use the no command to disable the sending of SNMP notifications.
snmp-server enable traps port-security [trap-rate TRAP-RATE]
Specifies the ID of the interface to be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies to display all the secure MAC addresses, including both
configured and learned entries.
(Optional) Specifies to display port security settings for the VLAN.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is allowed before and after the
comma.
(Optional) Specifies a range of VLANs. No space is allowed before and
after the hyphen.
P:Permanent
Max Curr Violation
No. No. Act.
5 2 Restrict
10 10 Shutdown
10 0 Shutdown
Violation Security Admin
Count Mode
0 D
0 D
0 P
985
Current
State State
Enabled Forwarding
Enabled Err-disabled
Disabled -