D-Link DXS-3600 Series Cli Reference Manual page 564

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
46-9 ip igmp snooping proxy-reporting
This command is used to enable the proxy-reporting function. Use the no form of this command to disable
the proxy-reporting function.
ip igmp snooping proxy-reporting [source IP-ADDRESS]
no ip igmp snooping proxy-reporting
Parameters
IP-ADDRESS
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. When the function proxy reporting is
enabled, the received multiple IGMP report or leave packets for a specific (S, G) will be integrated into
one report before being sent to the router port. Proxy reporting source IP will be used as source IP of the
report, Zero IP address will be used when the proxy reporting source IP is not set. Interface MAC will be
used as source MAC of the report. If the VLAN has no IP address configured, then system MAC will be
used.
Example
This example shows how to enable IGMP snooping proxy-reporting on VLAN 1 and configure the proxy-
reporting message source IP to be 1.2.2.2.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-if)# ip igmp snooping proxy-reporting source 1.2.2.2
Switch(config-if)#
46-10 ip igmp snooping querier
This command is used to enable the capability of the entity as an IGMP querier. Use the no form of this
command to disable the querier function.
ip igmp snooping querier
no ip igmp snooping querier
Parameters
None.
(Optional) Specifies the source IP of proxy reporting. The default value
is zero IP.
559