D-Link DXS-3600 Series Cli Reference Manual page 1282

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
10giga
master | slave
40giga
auto
SPEED-LIST
rj45
sfp
Default
By default, the speed will be automatic for 1000BASE-T and 10GBASE-T interfaces.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the specified speed is not supported by the hardware, error messages will be returned. For a
1000BASE-T connection, if the speed is specified to 1000Mbps, the port must be configured as master or
slave. For a 10GBASE-T connection, if the speed is specified to 10Gbps, the port must be configured as
master or slave.
If speed is set to 1000Mbps, 10Gbps, or 40Gbps then the duplex mode cannot be set to half-duplex. If the
duplex mode is set to half-duplex, then the speed cannot be set to 1000Mbps, 10Gbps or 40Gbps.
Auto-negotiation will be enabled if either the speed parameter is set to auto, or the duplex parameter is
set to auto. If the speed parameter is set to auto, and the duplex parameter is set to the fixed mode. Only
the speed will be negotiated. The advertised capability will be configured to the duplex mode combined
with all the possible speeds. If the speed is to set to a fixed speed and duplex is set to auto, only the
duplex mode is negotiated. The advertised capability will be both full and half-duplex mode combined with
the configured speeds.
For 10GBASE-R connections, if auto-negotiation is enabled, the system will automatically configure the
speed (1000M or 10G) according to the type of SFP/SFP+.
Example
This example shows how to configure Ethernet 1/1/1 to only auto-negotiate to 10Mbps or 100Mbps.
Switch# configure terminal
Switch(config)# interface ethernet 1/1/1
Switch(config-if)# speed auto 10,100
Switch(config-if)#
Specifies to force the speed to 10Gbps.
Specifies the port operates as master or slave timing. This parameter
is only applicable to 10GBASE-T connections.
Specifies to force the speed to 40Gbps.
Specifies that for copper ports, it specifies to determine the speed and
flow control via auto-negotiation with its link partner.
Specifies that for fiber ports (1000BASE-SX/LX), it enables the auto-
negotiation option. Auto-negotiation will start to negotiate the clock and
flow control with its link partner.
(Optional) Specifies a list of speeds that the switch will only auto-
negotiate to. The speed can be 1000, and/or 10giga. Use a comma (,)
to separate multiple speeds. If the speed list is not specified, all speed
will be advertised.
(Optional) Specifies to configure speed for RJ45 media. For combo
ports, if RJ45 or SFP/SFP+ is not specified, RJ45 is used.
(Optional) Specifies to configure speed for SFP/SFP+ media.
1277