D-Link DXS-3600 Series Cli Reference Manual page 815

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to configure an MSDP peer 10.1.1.1 as the static RPF peer.
Switch# configure terminal
Switch(config)# ip msdp static-rpf 10.1.1.1 rp-list rplist1
Switch(config)#
68-17 ip msdp mesh-group
This command is used to add an MSDP peer to the specified mesh group. Use the no command to
remove an MSDP peer from the mesh group.
ip msdp mesh-group PEER-ADDRESS MESH-NAME
no ip msdp mesh-group PEER-ADDRESS
Parameters
PEER-ADDRESS
MESH-NAME
Default
By default, the mesh group is not defined.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Before adding an MSDP peer to the mesh group, an MSDP peer must be added first using the ip msdp
peer command. If an MSDP peer has been added to multiple mesh groups, only the last configuration
takes effect.
Example
This example shows how to add the MSDP peer 10.1.1.1 to the mesh group "mesh1".
Switch# configure terminal
Switch(config)# ip msdp mesh-group 10.1.1.1 mesh1
Switch(config)#
68-18 clear ip msdp peer
This command is used to clear the TCP connection to the specified MSDP peer.
clear ip msdp peer [PEER-ADDRESS]
Parameters
PEER-ADDRESS
Specifies the MSDP peer IP address.
Specifies the name of the mesh group.
(Optional) Specifies the MSDP peer IP address.
810