D-Link DXS-3600 Series Cli Reference Manual page 1393

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no maximum routes
Parameters
LIMIT
WARN-THRESHOLD
warning-only
Default
By default, there is no limit.
Command Mode
VRF Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to limit how many routes can be allowed within the VRF. This limit only applies to
the active route. To only get a notification, set the warning-only option.
Example
This example shows how to configure the VRF VPN-A's routes limit to 100.
Switch# configure terminal
Switch(config)# ip vrf VPN-A
Switch(config-vrf)# maximum routes 100 warning-only
Switch(config-vrf)#
120-6 rd
This command is used to configure the Route Distinguisher (RD) of one VRF.
rd ROUTE-DISTINGUISHER
Parameters
ROUTE-DISTINGUISHER
Default
None.
Command Mode
VRF Configuration Mode.
Specifies the maximum number of routes within the VRF. Its range is
from 1 to 16384.
Specifies the warning threshold value in percentage. A notification
message will be sent when the routes number reach the threshold and
no more routes can be written into the hardware. Its range is from 1 to
100.
Specifies that when the route numbers exceeds the threshold, a
notification message will be sent, but more routes can be written into
hardware.
Specifies the VRF's route distinguisher, which is used to prepend an 8-
bytes value to an IPv4 prefix to create a VPN-IPv4 prefix.
1388