D-Link DXS-3600 Series Cli Reference Manual page 967

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
PRIORITY
Default
By default, the router priority is 1.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Set the priority to help determine the OSPF Designated Router (DR) for a network. If two routers attempt
to become the DR, the router with the higher router priority becomes the DR. If the router priority is the
same for two routers, the router with the higher router ID takes precedence.
Only routers with nonzero router priority values are eligible to become the designated or backup
designated router. Configure router priority for multi-access networks (not point-to-point) only.
Example
This example shows how to set the router priority value to 4.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 ospf priority 4
Switch(config-if)#
76-14 ipv6 ospf retransmit-interval
This command is used to specify the time between LSA retransmissions for adjacencies belonging to the
interface. To return to the default value, use the no form of this command.
ipv6 ospf retransmit-interval SECONDS
no ipv6 ospf retransmit-interval
Parameters
SECONDS
Default
The default interval is 5 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the number value of the priority of the router. The range is
from 0 to 255.
Specifies the interval the router waits before it retransmits a packet.
The valid setting is 1-65535.
962