D-Link DXS-3600 Series Cli Reference Manual page 1147

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
matched, all the set statements in the rule will be performed if the entry is a permit entry. The route will be
denied if the matched rule is a deny entry.
Example
This example shows how to create a rule entry with the sequence number 1 for route map "myPolicy".
Switch# configure terminal
Switch(config)# route-map myPolicy permit 1
Switch(config-route-map)# set community 1:1
Switch(config-route-map)#
91-8 show route-map
This command is used to display information about the route map.
show route-map [ROUTE-MAP-NAME]
Parameters
ROUTE-MAP-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the route map information.
Example
This example shows how to display the route map information.
Switch# show route-map
Route Map mypolicy, permit, sequence 1
Match clauses:
ip address myacl
Set clauses:
next-hop 100.1.1.1
Total Entries: 1
Total Route Map Counts : 1
Switch#
91-9 set ip default next-hop
(Optional) Specifies the route map to be displayed.
1142