D-Link DXS-3600 Series Cli Reference Manual page 1325

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, this option is 0x8100.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
An 802.1Q tunnel port behaves as an UNI port of a service VLAN. The trunk ports which are tagged
members of the service VLAN behave as the NNI ports of the service VLAN.
Only configure the 802.1Q tunneling Ethernet type on ports that are connected to the provider bridge
network, which receives and transmits the service VLAN tagged frames. If the tunnel Ethernet type is
configured, the specified value will be the TPID in the outer VLAN tag of the transmitted frames out of this
port. The specified TPID is also used to identify the service VLAN tag for the received frame on this port.
Example
This example shows how to configure the 802.1Q tunneling TPID on interface Ethernet 1/0/1 to 0x88a8.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# switchport mode trunk
Switch(config-if)# dot1q tunneling ethertype 0x88a8
Switch(config-if)#
115-3 switchport mode dot1q-tunnel
This command is used to specify the switch port to operate as a dot1q tunnel port.
switchport mode dot1q-tunnel
Parameters
None.
Default
By default, the switch port is operated as a hybrid port.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to specify the switch port to operate as a dot1q tunnel port.
Example
This example shows how to specify the switch port to operate as a dot1q tunnel port.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/2
Switch(config-if)# switchport mode dot1q-tunnel
Switch(config-if)# switchport access vlan 100
1320