D-Link DXS-3600 Series Cli Reference Manual page 608

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, this feature is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command only on broadcast media in a network of only two networking devices exist. This
command will cause the system to issue packets as point-to-point rather than as broadcasts. Configure
this command on both networking devices in the network.
Example
This example shows how to configure interface VLAN 1 to act as a point-to-point interface.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# isis network point-to-point
Switch(config-if)#
48-21 isis password
This command is used to configure the authentication password for an interface. Use the no command to
disable authentication.
isis password PASSWORD [level-1 | level-2]
no isis password [level-1 | level-2]
Parameters
PASSWORD
level-1
level-2
Default
By default, no password is specified.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command enables the prevention of unauthorized routers from forming adjacencies with this router,
and thus protects the network from intruders. The password is exchanged as plain text and thus provides
only limited security. Different passwords can be assigned for different routing levels using the level-1
Enter the 16-byte, plain-text password here.
(Optional) Specifies the authentication password for level 1
independently.
(Optional) Specifies the authentication password for level 2
independently.
603