D-Link DXS-3600 Series Cli Reference Manual page 808

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
68-7 ip msdp peer shutdown
This command is used to shut down the TCP connection between two peers. Use the no command to
configure the MSDP peer to the no shutdown state.
ip msdp peer shutdown PEER-ADDRESS
no ip msdp peer shutdown PEER-ADDRESS
Parameters
PEER-ADDRESS
Default
By default, the MSDP peer is in the no shutdown state.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The shutdown state must be configured on an existing MSDP peer. If the MSDP peer is in the shutdown
state, the TCP connection between two peers won't be established. If the MSDP peer was changed into
the no shutdown state, the TCP connection between two peers will attempt to re-establish.
Example
This example shows how to shut down the peer 10.1.1.1.
Switch# configure terminal
Switch(config)# ip msdp peer shutdown 10.1.1.1
Switch(config)#
68-8 ip msdp peer password
This command is used to enable MD5 password encryption for a TCP connection between two peers.
Use the no command to disable MD5 password encryption.
ip msdp peer password PEER-ADDRESS PASSWORD
no ip msdp peer password PEER-ADDRESS
Parameters
PEER-ADDRESS
PASSWORD
Default
By default, the MD5 password encryption is disabled.
Command Mode
Specifies the MSDP peer IP address.
Specifies the MSDP peer IP address.
Specifies the MD5 password.
803