D-Link DXS-3600 Series Cli Reference Manual page 1281

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
auto
normal
cross
Default
By default, this option is set as auto.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command cannot be applied to a port when the medium of the port interface is fiber.
Example
This example shows how to configure the MDIX state of interface Ethernet 1/1/1 to auto:
Switch# configure terminal
Switch(config)# interface ethernet 1/1/1
Switch(config-if)# mdix auto
Switch(config-if)#
108-4 speed
This command is used to configure the physical port interface's speed settings. Use the no form of
command to revert to the default setting.
NOTE: 10G does not support speed configurations of 10Mbps and 100Mbps.
speed {10 | 100 | 1000 [master | slave] | 10giga [master | slave] | 40giga | auto [SPEED-LIST]}
[rj45 | sfp]
no speed [rj45 | sfp]
Parameters
10
100
1000
master | slave
Specifies to set the port interface's MDIX state to the auto-MDIX mode.
Specifies to force the port interface's MDIX state to the normal mode.
Specifies to force the port interface's MDIX state to the cross mode.
Specifies to force the speed to 10Mbps.
Specifies to force the speed to 100Mbps.
Specifies that for copper ports, it forces the speed to 1000Mbps and
the user must manually set that the port operates as master or slave.
Specifies that for fiber ports (1000BASE-SX/LX), the port will disable
the auto-negotiation.
Specifies the port operates as master or slave timing. This parameter
is only applicable to 1000BASE-T connections.
1276