D-Link DXS-3600 Series Cli Reference Manual page 439

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 1.
Usage Guideline
This command is used to display DVMRP route information.
Example
This example shows how to displays route information.
Switch# show ip dvmrp route
State: H = Hold-down
Source Network
----------------
10.10.11.0/24
Total Entries: 1
Switch#
Display Parameters
Source Network
Upstream neighbor
Learned
Interface
State
ExpTime
Upstream Neighbor Metric
----------------- ------
0.0.0.0 1
The source IP address or source network.
The next hop router to the source network. Use 0.0.0.0 since this route
is a local interface entry and does not enable DVMRP. If the interface
is a local entry, then the up-stream neighbor displays the interface IP
address.
Indicates this route entry is a local interface. The other condition is
dynamically learned.
The interface to the source network.
The route state displays "H" if the DVMRP route is in the "Hold-down"
state.
The amount of time remaining until the entry is removed from the
DVMRP routing table. A dash note indicates that this entry is not going
to be removed (because it is a local interface).
434
Learned Interface
------- --------- -----
Local vlan1
State ExpTime
------
H -